Will VZ parts fit a VY?

VZ non SS guards are the same as VY so you can just fit the VZ SS guards to the VY. So the Parts needed are.

Is VY Bonnet same as VZ?

I believe the Vy and VZ bonnets are the same physical size, but the lines either side of the bonnet are higher ( ridged vz) Vz would not meet up with the bar so well at the end of the ridges Edit VZ monaro is like the earlier bonnets in size.

What motor is in a VY Commodore?

Engines: 3.8L V6: ECOTEC 3800. 3.8L Supercharged V6: Supercharged ECOTEC 3800. 5.7L V8: GenIII LS1 V8.

Will a VT bonnet fit a VY?

The VZ monaro front end Bonnet, lights, front bar (guards are same as vt/vx) will fit VT/VX and if you change the guards back to VT/VX you can fit it to VY. :D. The vents in the scoop are cosmetic only the mesh has black plastic behind. If it didn’t you woul get heaps of crap in the engine bay, water, bugs, dust.

When did the Commodore VY Series start and end?

Released in September 2002 and produced until August 2004 (with a Series II released in August 2003), the VY series was the first major design departure (both inside and out) of the third generation Commodore range released in August 1997.

How much horsepower does a Holden VE Series 2 have?

The 3.0L produces 190 kW (255 hp), more than the earlier 3.6L and more than the old 5.0L Holden V8. The new 3.6 produces a fraction more at 210 kW (282 hp) although the difference is negligible in real world driving. In mid-2010 Holden released the VE Series 2 (VEII).

When did Holden replace the VY with Adventra?

Holden replaced the VY II with the VZ Adventra in 2004. An interim VZ Adventra appeared in August 2004 at the time of the release of the VZ Commodore range, but this was in essence the familiar VY body with VZ engine, running gear, ECU and a VZ compliance plate.