How much does it cost to convert a hard top jeep to a soft top?
both systems will run you anywhere from $200 to $900 depending on features other than it’s just 8 bolts off and 6 bolts on …
How long does it take to put a soft top on a jeep?
Well-Known Member. Pretty simple and straightforward install. It took me about 2 hours to install it the first time.
Can you have both hard and soft top for jeep?
Can You Put a Hard Top On a Soft Top Jeep? Yes, you can put on a hard top on any Jeep so long as the hard top is made for your year and model Jeep. If you’re contemplating putting a hard top over your existing soft top, we would heavily advise against it. Hard tops are designed to fit seamlessly with your Jeep’s body.
How do you put a soft top back on a Jeep Wrangler?
How do I put the soft top back up? Step 1: Slide the lever to the unlock position on each side of the soft top. Step 2: At the rear of the Jeep, grab the soft top material and push it upward onto the top of the Wrangler to allow it to slide along the guide track and lock.
Which side of Jeep top goes on first?
Driver side. Passenger side has to go on first and come off last.
How long does it take to install a soft top?
How long does it take to install Jeep soft top?
Pretty simple and straightforward install. It took me about 2 hours to install it the first time.
How to install Mopar JL Wrangler soft top kit?
How To Install The Mopar JL Wrangler Soft Top Kit On Your Jeep. 1 Step 1. First you will need to assemble the rear door surrounds. Door surrounds will be labeled left and right. Use the provided door surround seals 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
How to install a Jeep Wrangler Sportbar top?
You can leave the protective cover and straps on until you get the top situated on the back of the Jeep, this will make it easier to move around and handle. Once the top is placed on the back remove the arm straps. Take the lower arms and place them in the sportbar brackets. Now use the two T40 bolts to fasten it in place.
How do you install a soft top canopy on a jeep?
So now you have your door surrounds installed but you need to install the soft top canopy. The soft top canopy is held to the roll bar with four torx T30 bolts. These bolts are installed into the plastic ends of the soft top frame as shown below: These bolts are also often missing from the jeep top.
How to install weather seals on a Jeep Wrangler?
Be careful to not crush the weather seal on top of the B-pillar between the front and rear door of the Wrangler. Now flip the hinged pieces of the surround up and insert the bolts the same way as the fronts. Tighten down both bolts.